WASTEWATER INFRASTRUCTURE POLLUTION PREVENTION AND ENVIRONMENTAL SAFETY ACT

WASTEWATER INFRASTRUCTURE POLLUTION PREVENTION AND ENVIRONMENTAL SAFETY ACT

Congressional Record, Volume 172 Issue 53 (Sunday, March 22, 2026) [Congressional Record Volume 172, Number 53 (Sunday, March 22, 2026)] [Senate] [Pages S1521-S1522] From the Congressional Record Online through the Government Publishing Office [ www.gpo.gov ] WASTEWATER INFRASTRUCTURE POLLUTION PREVENTION AND ENVIRONMENTAL SAFETY ACT Mr. BARRASSO. Mr. President, I ask unanimous consent that the Senate proceed to the immediate consideration of Calendar No. 166, S. 1092. The ACTING PRESIDENT pro tempore. The clerk will report the bill by title. The legislative clerk read as follows: A bill (S. 1092) to require certain products to be labeled with `Do Not Flush' labeling, and for other purposes. There being no objection, the Senate proceeded to consider the bill, which had been reported from the Committee on Commerce, Science, and Transportation with an amendment to strike all after the enacting clause and insert the part printed in italic, as follows: SECTION 1. SHORT TITLE. This Act may be cited as the ``Wastewater Infrastructure Pollution Prevention and Environmental Safety Act'' or the ``WIPPES Act''. SEC. 2. ``DO NOT FLUSH'' LABELING. (a) In General.--A covered entity shall label a covered product with the label notice and symbol, in accordance with subsections (b) and (c). (b) Requirements.-- (1) Cylindrical packaging.--In the case of a covered product sold in cylindrical or near-cylindrical packaging, and intended to dispense individual wipes-- (A) the symbol and label notice shall be displayed on the principal display panel in a clear and conspicuous location reasonably visible to the user each time a wipe is dispensed; or (B) the symbol shall be displayed on the principal display panel and the label notice, or a combination of the label notice and symbol, shall be displayed on a flip lid in a manner that covers at least 8 percent of the surface area of the flip lid. (2) Flexible film packaging.--In the case of a covered product sold in flexible film packaging, and intended to dispense individual wipes-- (A) the symbol shall be displayed on the principal display panel and, if the principal display panel is not on the dispensing side of the packaging, on the dispensing side panel; and (B) the label notice shall be displayed on either the principal display panel or the dispensing side panel, in a clear and conspicuous location reasonably visible to the user each time a wipe is dispensed. (3) Rigid packaging.--In the case of a covered product sold in a refillable tub or other rigid packaging that may be reused by a customer, and that is intended to dispense individual wipes, the symbol and label notice shall be displayed on the principal display panel in a clear and conspicuous location reasonably visible to the user each time a wipe is dispensed. (4) Packaging not intended to dispense individual wipes.-- In the case of a covered product sold in packaging that is not intended to dispense individual wipes, the symbol and label notice shall be displayed on the principal display panel in a clear and conspicuous location reasonably visible to the user of the covered product. (5) Bulk packaging.-- (A) In general.--In the case of a covered product sold in bulk at retail, the symbol and label notice shall be displayed on both the outer packaging visible at retail and the individual packaging contained within the outer packaging. (B) Exemption.--The following shall be exempt from the requirements of subparagraph (A): (i) Individually packaged covered products that are contained within outer packaging, are not intended to dispense individual wipes, and have no retail labeling. (ii) Outer packaging that does not obscure the symbol and label notice on individually packaged covered products contained within. (6) Packaging of combined products.-- (A) Outer packaging.--The outer packaging of combined products shall be exempt from the symbol and label notice requirements of subsection (a). (B) Packages less than 3 by 3 inches.--In the case of a covered product in packaging smaller than 3 inches by 3 inches (such as an individually packaged wipe in tear-top packaging) and sold as part of a combined product, if a symbol and label notice are placed in a prominent location reasonably visible to the user of the covered product, such covered product shall be considered to be labeled clearly and conspicuously. (c) Reasonable Visibility of Symbol and Label Notice.-- (1) In general.--A covered entity shall ensure that-- (A) packaging seams or folds or other packaging design elements do not obscure the symbol or label notice; (B) the symbol and label notice are each equal in size to at least 2 percent of the surface area of the principal display panel; and (C) the symbol and label notice have high contrast with the immediate background of the packaging so that such symbol and label notice may be seen and read by an ordinary individual under customary conditions of purchase and use. (2) Proximity of symbol and label notice.--A covered entity may display a symbol and label notice either adjacent to or on separate areas of the principal display panel. (3) Exception.--Paragraph (1)(C) does not apply to an embossed symbol or label notice on the flip lid of a covered product sold in cylindrical or near-cylindrical packaging. (d) Representations of Flushability.--With respect to a covered product, a covered entity may not make any express or implied representation that such covered product can or should be flushed. (e) Enforcement by Federal Trade Commission.-- (1) Unfair or deceptive acts or practices.--A violation of this section shall be treated as a violation of a rule defining an unfair or deceptive act or practice prescribed under section 18(a)(1)(B) of the Federal Trade Commission Act (15 U.S.C. 57a(a)(1)(B)). (2) Powers of commission.--The Commission shall enforce this section in the same manner, by the same means, and with the same jurisdiction, powers, and duties as though all applicable terms and provisions of the Federal Trade Commission Act (15 U.S.C. 41 et seq.) were incorporated into and made a part of this section. (3) Privileges and immunities.--Any person who violates this section shall be subject to the penalties and entitled to the privileges and immunities provided in the Federal Trade Commission Act (15 U.S.C. et seq.). (4) Authority preserved.--Nothing in this section shall be construed to limit the authority of the Commission under any other provision of law. (f) Commission Guidance.-- Not later than 180 days after the date of enactment of this Act, the Commission, in consultation with the Administrator of the Environmental Protection Agency, the Commissioner of Food and Drugs, the Consumer Product Safety Commission, and any other agency determined appropriate by the Commission, shall issue guidance to assist covered entities in complying with the requirements of this section. (g) Limitation on Commission Guidance.-- (1) In general.--No guidance issued by the Commission with respect to this section shall-- (A) confer any rights on any person, State, or locality; or (B) bind the Commission or any person to the approach recommended in such guidance. (2) Specific violations.--In any enforcement action brought under this section, the Commission shall allege a specific violation of a provision of this section. (3) No enforcement actions based on guidance.--The Commission may not base an enforcement action on, or execute a consent order based on, practices that are alleged to be inconsistent with any guidance issued under this Act, unless the practices allegedly violate this section. (h) Preemption of State Laws.--No State or political subdivision of a State may directly or indirectly establish or continue in effect, under any authority, requirements with respect to the ``Do Not Flush'' labeling of covered products that are not identical to the requirements of this section. (i) Definitions.--In this section: (1) Combined product.--The term ``combined product'' means two or more products sold in shared retail packaging, of which-- (A) at least one of the products is a covered product; and (B) at least one of the products is another consumer product intended to be used in combination with such covered product. (2) Commission.--The term ``Commission'' means the Federal Trade Commission. [[Page S1522]] (3) Covered entity.--The term ``covered entity'' means a manufacturer, wholesaler, supplier, individual or group of individuals, or retailer that is responsible for the labeling or retail packaging of a covered product that is sold or offered for retail sale within the United States. (4) Covered product.-- (A) In general.--The term ``covered product'' means a premoistened, nonwoven disposable wipe sold or offered for retail sale-- (i) that is marketed as a baby wipe or diapering wipe; or (ii) that is a household or personal care wipe (including a wipe described in subparagraph (B)) that-- (I) is composed entirely, or in part, of petrochemical- derived fibers; and (II) has significant potential to be flushed. (B) Inclusions.--The wipes described in this subparagraph are-- (i) antibacterial wipes and disinfecting wipes; (ii) wipes intended for general purpose cleaning or bathroom cleaning, including toilet cleaning and hard surface cleaning; and (iii) wipes intended for personal care use on the body, including hand sanitizing, makeup removal, feminine hygiene, adult hygiene (including incontinence hygiene), and body cleansing. (5) High contrast.--The term ``high contrast'' means, with respect to the symbol or label notice, that such symbol or label notice-- (A) is either light on a solid dark background or dark on a solid light background; and (B) has a contrast percentage of at least 70 percent between such symbol or label notice and the background, using the formula (B1-B2)/B1 * 100 = contrast percentage, where B1 is the light reflectance value of the lighter area and B2 is the light reflectance value of the darker area. (6) La

Referenced legislation: S1092, S1092